Search results

Thank you guys for your help with this issue. MDOT finally got back with me and they had an issue on their end. Waste of a day!

I've sent an email to them and we will see what they have to say. Thanks for all of your help Adam!

BRIG would be the nearest site.

When I choose TCP it does not allow me to select a mountpoint. I can only select my mountpoint when using NTRIP. This is the way we have had is setup since we first received our LS in 2015.

No problem. I'll leave it connected.

Sure thing. sn#00176

Thanks Adam. I checked the settings and the NMEA period was set to 10 seconds so I changed it to 5 seconds with the same results. We upgraded to the LS+ a few months ago and haven' had any issues until now.

We were getting ready for the field today and can't seem to get our LS+ connected to our local CORS sites. This happens with both Wifi and LAN connections. RTN Status will say "SOCKET FAILED" then turns to "ERROR TIMEOUT". I've tried turning the RTN configuration on and off, disabling the...

We are having the same issues here in Michigan. I tried to upload a file, approx. 3 hours, from last Wednesday and it stated the same "Reference observations not available at the moment."

One of the corners on our Triumph-2 has cracked as well. The case with the rubber corners was installed on our Triumph-2 when it was sent in for the board upgrade.

We recently sent our Triumph-2 in for the Base Guard update. I am trying to set up the base and I cannot get the Triumph-2 to pair with the external radio (HPT435BT). How do I get the bluetooth to pair?

Matt: I believe that I do have a good connection with the conducting shield. I have ordered the new updated antennae and we will see what happens.

We had the same issue with the broken antenna connection at the ground plane a week or so ago. I disassembled the base of the antenna unsoldered and resoldered the cable back on. Then we secured the cable to the ground plane so we wouldn't have this issue again. I've checked the continuity...

I thought that I recently read a post of a future software update that would allow a user to occupy and start recording a point, pause the recording (while a car comes barreling down the road) and then be able to reoccupy the point and continue recording until required "standards" are met. Has...

We used the LS to stake out some silt fence and rough grade stakes yesterday in the field. After staking and recording a point,is it possible to store the "as-staked" point as a different point number rather than the LS storing an "as-staked" point with the same number as the design point number?

Is it possible to set the user defined buttons as "quick setup settings", i.e. U1: Boundary settings - 30 epochs, Verify w/reset, etc.; U2: Topo settings - 3-5 epochs, Verify w/o reset, etc.... without having to manually change the setting each time? Maybe an option for a future software release?

Has anyone experienced the LS freezing (screen goes blank and the battery lights flash) while recording a point? This has occurred on a few occasions now both with CORS and UHF setups. I've had to reset the unit by holding down the power button for 10 seconds. Once I reset the unit...

That did it! Same as you, I must have spent an hour before finally posting this! Thanks!!

We were in the field yesterday on a 55 acre parcel of land using MDOT (Michigan Dept. of Trans.) CORS and on two separate occasions the LS turned off while recording a point. I was able to restart the unit and continue working. I checked back into a few points that we recorded both earlier in...