Alignment Verticals

Bruce Dawson

Active Member
So I am using the Alignment routine to stake a small road and was struggling to get my verticals to work. I defined the horizontal and it all worked great, but I got no usable cut/fill numbers. I had input the vertical data, but it did not show up in Preview, and all I got was a cut to a zero elevation. After some experimenting, I found that you have to have a Cross Section defined. It doesn't have to be much, a simple 0 offset, 0 distance will give you centerline cut/fills, but you have to have something.

Just passing along my solution in case others have similar issues.

Bruce
 
Top