Sean Joyce
Well-Known Member
I typically create an alignment of a boundary for line marking and staking using stake line here.
The stationing follows the direction the alignment was created, However many times I jump around to different sections of the alignment and stake the line in the opposite direction.
The offset value is shown left or right according to the direction of the stationing so left becomes right and right becomes left if working the stationing backwards. (reminds me of using the inverted T2's). Is there currently a way (short of creating 2 alignments) to flip the direction of the offsets (by designating direction of stakeout) depending on where you are and what direction you are working in the alignment?
If not how about a direction of stakeout toggle?
The stationing follows the direction the alignment was created, However many times I jump around to different sections of the alignment and stake the line in the opposite direction.
The offset value is shown left or right according to the direction of the stationing so left becomes right and right becomes left if working the stationing backwards. (reminds me of using the inverted T2's). Is there currently a way (short of creating 2 alignments) to flip the direction of the offsets (by designating direction of stakeout) depending on where you are and what direction you are working in the alignment?
If not how about a direction of stakeout toggle?