Robert P Stenerson
Active Member
Greetings:
I hope this isn't a RTFM question, and I've only seen it mentioned previously in a thread about point to a line, but is there a way to set the default Cogo Basic Inverse direction display to show Bearings instead of North Azimuths? While I'm asking can the other Cogo operations like transverse, be set to default to entering Bearings without me having to always start by tapping the bearing button?
Thanks,
Rory
P.S. This would save me from on-the-fly miscalculating in my head, or trying to find my hand calculator, and also the scorn of my Chief Surveyor who is not a J-Field affectionato.
I hope this isn't a RTFM question, and I've only seen it mentioned previously in a thread about point to a line, but is there a way to set the default Cogo Basic Inverse direction display to show Bearings instead of North Azimuths? While I'm asking can the other Cogo operations like transverse, be set to default to entering Bearings without me having to always start by tapping the bearing button?
Thanks,
Rory
P.S. This would save me from on-the-fly miscalculating in my head, or trying to find my hand calculator, and also the scorn of my Chief Surveyor who is not a J-Field affectionato.
