Bruce Dawson
Active Member
Hello everyone,
I am a relatively new user that has become comfortable with using my Triumph-LS with a Triumph 2 base in RTK mode. I would like to know what the steps are for getting the base data in a format that can be uploaded to DPOS or OPUS for processing of the base point location. I have tried looking through other posts, and it looks like you should be able to download that information from the Triumph 2, but frankly I am not able to follow those conversations very well. Here is my current operational steps:
1) I work pretty much exclusively in NAD 83/11, Washington State Coordinate System North Zone. I have created 2 Setups for the monopod and a bipod using that coordinate system. They are both setup as Rovers. I have not created a Standalone Setup.
2) If there is not a published control monument to use when I get to a jobsite, I just use an autonomous position on a set point or a found point where my base is setup. I know that when I start the base, I connect to the broadcasting corrections, and usually the data for the base point being used is not correct, that is it is from a previous job somewhere else. So I have to stop the base and at that point there is the option to download the data. I do this, and start the base again with the correct HI and autonomous position.
3) I do my work. My thought is that I should be able to stop the base from the LS and get the option to download the data, which I am guessing is the data to send to DPOS or OPUS. I do not get that option, however, and usually just turn everything off. If I try and go back to the Base/Rover Setup it shows that I do not have a connection and therefor nothing to stop. But in all my Collect or Stakeout screens it shows good signal and everything checks.
What am I missing?
Thanks!
I am a relatively new user that has become comfortable with using my Triumph-LS with a Triumph 2 base in RTK mode. I would like to know what the steps are for getting the base data in a format that can be uploaded to DPOS or OPUS for processing of the base point location. I have tried looking through other posts, and it looks like you should be able to download that information from the Triumph 2, but frankly I am not able to follow those conversations very well. Here is my current operational steps:
1) I work pretty much exclusively in NAD 83/11, Washington State Coordinate System North Zone. I have created 2 Setups for the monopod and a bipod using that coordinate system. They are both setup as Rovers. I have not created a Standalone Setup.
2) If there is not a published control monument to use when I get to a jobsite, I just use an autonomous position on a set point or a found point where my base is setup. I know that when I start the base, I connect to the broadcasting corrections, and usually the data for the base point being used is not correct, that is it is from a previous job somewhere else. So I have to stop the base and at that point there is the option to download the data. I do this, and start the base again with the correct HI and autonomous position.
3) I do my work. My thought is that I should be able to stop the base from the LS and get the option to download the data, which I am guessing is the data to send to DPOS or OPUS. I do not get that option, however, and usually just turn everything off. If I try and go back to the Base/Rover Setup it shows that I do not have a connection and therefor nothing to stop. But in all my Collect or Stakeout screens it shows good signal and everything checks.
What am I missing?
Thanks!
