And, unless I'm dreaming, it looks like an antenna height change made after a shot is stored (via the points edit page) is now reflected in the Star*Net vector. That's a greatly appreciated improvement, as I sometimes forget to change the antenna height in the LS until I've already stored the shot. (Like today, when I had to shoot a monument that I had to dig down almost 3 feet to recover. I had to switch to a 2-meter pole to get a shot that deep, but when I switched back to my regular pole I neglected to change the antenna height back until I caught the goof 2 points later.) In the past that rendered the exported vector of limited use, as it couldn't be used to adjust the point in Star*Net without going through some complicated steps to connect what look like 2 vertically-separated points. So thanks very much!