LS+ Cell corrections 101

[Chuck Oleinik]

Can someone point me to information on what I need to use cell corrections on my LS+?
I have the modem installed. I would like to use AT&T. I use a T3 as a base right now, but would like the
option to not have to set up the base if I have good cell service.
Thanks!

 

[hntwhitetail]

Can someone point me to information on what I need to use cell corrections on my LS+?
I have the modem installed. I would like to use AT&T. I use a T3 as a base right now, but would like the
option to not have to set up the base if I have good cell service.
Thanks!

Are you wanting to use your state supported cors network?

 

[Chuck Oleinik]

Are you wanting to use your state supported cors network?

Yes, that would be ideal.

 

[Matt Johnson]

Hi Chuck,

If you are wanting to use the cellular modem, you will need to install a SIM card. Once the SIM card is installed connect the cellular antenna and confirm it is connected to ATT network by clicking the GSM icon on the top of the screen. You can also use a hotspot from a phone or mobile hotspot device.

To change the correction stream on the LS tap the RTCM icon on the top of the screen. Then click Corrections via and select the Cellular Modem option.

You will then need to add a new NTRIP client by clicking the + button.

You need to request access from the state RTN if you have not done so yet. You then just need to enter the a name, host name, port, username, password, and then click Select from Source Table to pick a RTCM mountpoint. NMEA GGA should be checked.

Then confirm that it is connected to the network in the RTCM screen.

 

[Chuck Oleinik]

Perfect! Thanks for the info.