Wes Hand
Active Member
The following scenario occurs so often that it I just have been accustomed to it...not sure if others experience same issue.
I dial into our RTN and set my base point. I then set up base on said point and switch my general profile over to TCP for either the T1M or T3 base. I use a jetpack for the T1M and internal sim card for the T3. The wifi will show a connection with ip address etc but I wont get corrections. I manually disconnect the wifi connection and reconnect. 100% of the time it comes back in with no issue and I begin seeing delay and latency populate and I can go to work. This happens everyday and I've grown accustomed to it not being a problem because I know what to do to get everything working. But for new users this might be confusing. This issue occurs happens at least 70% (guessing) of the time when switching from general profiles using TCP. Any others seeing this?
I dial into our RTN and set my base point. I then set up base on said point and switch my general profile over to TCP for either the T1M or T3 base. I use a jetpack for the T1M and internal sim card for the T3. The wifi will show a connection with ip address etc but I wont get corrections. I manually disconnect the wifi connection and reconnect. 100% of the time it comes back in with no issue and I begin seeing delay and latency populate and I can go to work. This happens everyday and I've grown accustomed to it not being a problem because I know what to do to get everything working. But for new users this might be confusing. This issue occurs happens at least 70% (guessing) of the time when switching from general profiles using TCP. Any others seeing this?