Reboot after base/rover setup

Michael

Member
Okay. Set the base up on known point. Go through base/rover setup. Everything looks good on base/rover screen (no red showing, 2d delta fine). Disconnect blue tooth. Action screen, hit GNSS. The dreaded CDF shows up. Reboot Ls+ and go to action screen after reboot hit GNSS. All is fine, Green and engine numbers showing. Ready to use and no problems. Using LS+ and T-3 setup. Seems to be a constant thing on setup. Any Ideas would be appreciated. Mike
 

Michael

Member
Sorry. I am using TCP (cellular). There have been times where the T-3 base is powered on and cell doesn't light up and you have to power off and power on to get lit up. When we first got the units a couple of months ago, Adam had to get the sim cards straightened out and he got them working just fine. Next time I post, I will provide all the information that might be related to the problem ( my bad). By the the way we love using TCP for communications. Mike
 

Adam

Well-Known Member
5PLS
Sorry. I am using TCP (cellular). There have been times where the T-3 base is powered on and cell doesn't light up and you have to power off and power on to get lit up. When we first got the units a couple of months ago, Adam had to get the sim cards straightened out and he got them working just fine. Next time I post, I will provide all the information that might be related to the problem ( my bad). By the the way we love using TCP for communications. Mike
Give me a call in the morning Michael.
 
Top