Mitchell D Lane
Active Member
Is it possible to get a white box or two that completes a simple rotate and translate of selected design points or selected page? maybe "old bearing " and " new bearing". An ability to put enter a bearing with two points with a dash in between.
Example: select page 4 (with design points calc from old survey), old bearing is point 45-48. new bearing is points i just found and measured being 500-501. solve. it rotates the entire page.
example: translate by page or point range. old point 45, new pt 500. solve.
if there is a quick way to achieve this I have not found it.
Example: select page 4 (with design points calc from old survey), old bearing is point 45-48. new bearing is points i just found and measured being 500-501. solve. it rotates the entire page.
example: translate by page or point range. old point 45, new pt 500. solve.
if there is a quick way to achieve this I have not found it.