Search results

Du-oh forgot to check:( that haven't had any one use that freq around her for the last 6 months I'll try that today:oops:

I was trying to RTK survey yesterday and the LS would get a "receiving" once in a while and then 5- 42 seconds later there would be no connection to the base. I was 30 feet from the base and the radio. after 1 hour of this nonsense, I left the job and went back to the office to check the...

That seems to have done it thanks

the Triumph 2 is purchased so yes, the LS expires at the end of June; so OAF's are both current

The bluetooth light on the triumph 2 switches between blue and red every few seconds as the LS tries to connect to it -fails every time.

the actual message is "Unable to connect to external GNSS receiver!"

Have been using my units since Dec with no problems. Went to a job and every time I set up I get to the point of communicating with the Base and I get the message "Unable to communicate with external antenna". I've tried different setups, re-booting, turning the units off and on, nothing...

my antenna mast is a frost pit with two welded on brackets, one as a step to push it in with my boot in soft ground and one "l" shaped to slip EMT tubing on. I carry 3-5 ft sections, to splice together I use tread-all with nuts screwed on that fit inside the EMT one has a piece of mild steel in...

I carry the antenna in a padded case from an old level and the radio, flat plane, cable, tribrach and power cord fit in my old yellow 5700 pelican very well I use a frost pin with bracket and two pieces of EMT as a mast. The radio hangs on a piece of flat steel on a piece of threadall with nuts...