Search results

I used it without issue this morning

You grew your beard back!

thanks for the followup Rich

I'm pretty sure Adam is correct about the Windows platform on Carlson tablets

Nate, I should have mentioned that I leave my autonomous solution for the day in the field alone and temporarily use the shift function to move all of the rest of my file to my current autonomous solution.

Nate, I know this seems like a pretty basic response but your situation is something I do all of the time. I work in State Plane. After I DPOS a file upon return to the office I apply the combined factor to put the project on the ground. If I come back to the job at a later date and set...

FWIW Nate I DPOS wirelessly on my LAN router. I still use a thumb drive to get my files onto my PC, though.

Hey Nate, I'd be real tempted to take John up on that gracious offer. I know very little about radios and antennas but when you say welding shop I get worried something might interfere. Then again, it might just help, I sure don't know. Good luck

Alexey, it's great to see you chiming in!

I can't get into it either Greg.

That's great support as usual Alexey and Shawn! Thanks much

I just DPOS'd a couple of base files without issue

Yes, it worked fine for me this morning, many thanks

I was able to upload my raw data but the CORS processing for base just stalls and goes nowhere

Often with similar threaded problematic connections I wrap a small amount of surveyors' ribbon as a thread lock before assembling

It's absolutely worth it. It's like real-time DPOS only better.

So to update this thread my T3 did need a firmware upgrade, which I did, and now all is acting as it used to and as expected. Thanks Matt for jumping in and getting my noggin gears turning.

Thanks Matt. I am up to date on pre-release J-Field though I should probably check my T-3 firmware. I probably should try clearing the NVRAM manually on the T3 to see if that makes a difference although looking at it I'm not sure how to do that. It's definitely been behaving differently than...

I have a T3 - LS+ combo utilizing the T3 internal 1w UHF radio running J-Field pre-release 3.0.11.831. (I see a new update this morning I haven't done yet.) Often if I develop a glitch where the Base-Rover setup fails to give the correct responses I will go to the Base-Rover setup in the LS...

32 years