-
-
DPOS access to NGS / CORS base station data has been resolved. -
David M. Simolo reacted to Nate The Surveyor's post in the thread Radio coms are down, lets post process it. with
Like.
Shoot the point of interest several times. (depends on tree cover). I Like 3- 3 minute shots, in moderate canopy. Return to base, and... -
I'll start a thread, with a play by play....
-
David M. Simolo reacted to Nate The Surveyor's post in the thread Reset Factory Image - Step by Step - Play by Play with Like.
Unit is off. Press on. As it is turning on, a little HOUSE appears on the lower side of the screen. Press the HOUSE Hardware button...
-
David M. Simolo reacted to Rich Nelson's post in the thread Triumph T3 and Weak Cell Areas with Like.
I wanted to provide an update on my WiFi setup. I purchased a Cudy Outdoor AP 1.0 and 100ft PoE wire connected to my Fios Router. I...
-
Running some 'base' station 1-second RTK RTCM3 correction data transmission rates (to a 'rover') and measured the following throughput:-...
-
Dear Customers, DPOS is operational as of 20th June 2024. There was an interruption in CORS data transfer due to handshake changes from...
-
Harold, Try this: Points. Go up or down and FIND this particular point. Highlight it. Find 3 bar button in NW corner screen Press...
-
Dear Customers, We are aware of the interruption of the free DPOS service, and our team is working diligently to restore the operation...
-
David M. Simolo reacted to Matt Johnson's post in the thread Can't create file on SD card (Can't start logging) with Like.
If the card is full or not FAT32 formatted then you will receive this error.
-
David M. Simolo replied to the thread Geomagnetic Storms and Surveying.I feel like it may have been a little more difficult to get a fix at times but generally performance seems ok here in Upstate NY
-
Application Note: HPT435 as a Repeater.
-
David M. Simolo reacted to Matt Johnson's post in the thread Javad LS is Stuck and will not Stop Job. with Like.
1. Turn the receiver OFF with the ON/OFF button. 2. Press and hold the Record button. 3. Turn the receiver ON by pressing the ON/OFF...
-
David M. Simolo reacted to John Rosco's post in the thread Is JCORS a viable solution for those of you using it? Is it free to try? with Like.
Also: Remember to setup the correct JAVAD Triumph 'base' reference position ARP / APC values (and save). Plus update the NTRIP Caster...
-
David M. Simolo reacted to John Rosco's post in the thread Is JCORS a viable solution for those of you using it? Is it free to try? with Like.
For Internet connection access using a Static IP-Address. a) If using a JAVAD Triumph-1Mplus or a Triumph-3 'base' installed with a...
-
-
Loading…
-
Loading…