Nate The Surveyor
Well-Known Member
Went sour on me, on Friday.
It gave me some error codes. I wish I had taken a pic of the screen. But, I had put in a long day, and I was cold.
Anyway, I just gave up, in the field, came home, and did the following:
I went to BASE/ROVER setup.
Connected them, via bluetooth.
I clicked the button right below the GREEN "START BASE" button.
It says "TRIUMPH LS 435, and TRIUMPH2 728"
I get a screen "Remote Base"
I click "Manage Files" (Top Button)
Here, I get a list of BASE RECEIVER FILES.
I go to page 2
The very last file, Base2_085342, which I select. (when I select this file, then on the right hand screen, I get 01/06/2017 as its date)
Then, I click the green "Down Arrow", at the top of screen, between the red X and the Red Magnifying glass.
It now downloads.
However, it seems to have lost it's association to the Base2 file, and won't DPOS, or perform BASE to ROVER processing.
Any suggestions?
Could this be a failure to clear the NVRAM after the leap second?
Or, should I try to update the software in the T2?
My next step is going to be to look and see if there are any updates for the T2, using netview.
Thanks!
N
It gave me some error codes. I wish I had taken a pic of the screen. But, I had put in a long day, and I was cold.
Anyway, I just gave up, in the field, came home, and did the following:
I went to BASE/ROVER setup.
Connected them, via bluetooth.
I clicked the button right below the GREEN "START BASE" button.
It says "TRIUMPH LS 435, and TRIUMPH2 728"
I get a screen "Remote Base"
I click "Manage Files" (Top Button)
Here, I get a list of BASE RECEIVER FILES.
I go to page 2
The very last file, Base2_085342, which I select. (when I select this file, then on the right hand screen, I get 01/06/2017 as its date)
Then, I click the green "Down Arrow", at the top of screen, between the red X and the Red Magnifying glass.
It now downloads.
However, it seems to have lost it's association to the Base2 file, and won't DPOS, or perform BASE to ROVER processing.
Any suggestions?
Could this be a failure to clear the NVRAM after the leap second?
Or, should I try to update the software in the T2?
My next step is going to be to look and see if there are any updates for the T2, using netview.
Thanks!
N
