Nate The Surveyor
Well-Known Member
OK, I was on a job recently. Something was malfunctioning in the LS. I pressed the ON button, and did an all reset. (Long press of on button, until it shuts down).
It cleared all my settings for point descriptions. It never did this before.
When I used CLUSTER AVERAGE, all its settings were changed. It never did this before.
I carefully deleted all the _AVG points. Then, I discovered that it also did not copy the POINT DESCRIPTIONS, as normal. Then, what the heck is "BYPASS SINGLE POINTS"???
Does anybody use AVERAGE on single points? So, now I'm deleting all the funky cluster points. I was very frustrated. Start over.
Then, as I thought about it, I thought, why not ALLOW this place to average SINGLE points, as in, RTK, and RTPK points?
So......
And, WHY is there an average of SINGLE POINTS allowed, at this point?
Thanks,
Nate
It cleared all my settings for point descriptions. It never did this before.
When I used CLUSTER AVERAGE, all its settings were changed. It never did this before.
I carefully deleted all the _AVG points. Then, I discovered that it also did not copy the POINT DESCRIPTIONS, as normal. Then, what the heck is "BYPASS SINGLE POINTS"???
Does anybody use AVERAGE on single points? So, now I'm deleting all the funky cluster points. I was very frustrated. Start over.
Then, as I thought about it, I thought, why not ALLOW this place to average SINGLE points, as in, RTK, and RTPK points?
So......
And, WHY is there an average of SINGLE POINTS allowed, at this point?
Thanks,
Nate