avoidthelloyd
Active Member
I've had it happen a couple of times... I setup Auto base and tie control. Go back and stop base and download to DPOS it. When I get my calculations done at a nice little mom & pop diner I go back to the base and connect to the base and start it... OOPS. My base setup is still set to AUTO. I finish the job and go home. I find it later.
1. Can we get the LS to default to NEAREST in the Base Setup after a base point has been used in the project?
2. What all checks and balances do you guys use to catch this?
Thanks.
1. Can we get the LS to default to NEAREST in the Base Setup after a base point has been used in the project?
2. What all checks and balances do you guys use to catch this?
Thanks.