Duane Frymire
Active Member
I processed a point earlier today through the customer portal. Trying to dpos from the LS now and says no server connection. Wondering if DPOS is not working or I'm doing something wrong on LS.
Thanks Alexey. Tried again and no luck. Sending to support. LS# 167, project 2020-11-20A. I used an LS as base and started from auto. Brought it into the LS+ which was used as rover and trying to dpos base point #2 and points 10 through end of file. Used create base and dpos from file command.DPOS is up! Just rechecked. BTW you can send the project to Support.
Thanks Alexey. How do I access dpos'ed project? I did get a message from NYDOT that one of the cors I was using was down, but now back. Not sure if that affects things or not.In fact DPOS is working not stable last hours. We are trying to clear a reason. Just deposed your project successfully.
Thanks Alexey! You guys rock!
Alexey, Iooking at the file and something not correct. Coordinates in one column end up corrected in following columns I'm assuming. But the following column has same values for differing points. And, for instance 62 and 63 are both on the same point, they have slightly differing solutions but good repeat, but column to right shows same value for both, and shows same value for another point that's maybe 30 feet away. Also, 62 and 63 are on a point that I did 6 hours or so static on same day with T2 (which I was able to DPOS) and values are about 1 meter apart. I tried to dpos again both through the LS and just submitting the jps file of LS base session and neither works.
Only one base. Been in field, i'll check this later. Thank you for the efforts either way.We did our best. Two bases in a project its a problem for DPOS ing now.