Jim Campi
Active Member
Gentlemen,
The following problem has come up several times:
The DPOS displays a "1" adjacent to the file name on the LS's DPOS page, a current status of "wait" with a message that the system is determining "base file presence". When I see this it typically indicates there was a problem downloading the base file data to the rover.
My typical process is to connect the LS and T2 and download the base file. Generally this solves the problem. Today it didn't.
I deleted the file from the DPOS page on the LS, connected the LS and T2, downloaded the base file, went back to the DPOS page on the LS and the file is not in the list.
I have 2 questions:
1. Any thoughts on recovering this file? I downloaded the unprocessed point file to my PC before deleting above.
2. Since I am not seeing other complaints about this, there must be a problem with my process. I survey and download the point file (T2 to LS), disconnect and powerdown the LS, T2 and radio. Should I add to or modify this procedure to avoid this problem.
This comes up about every 5th project. Any thoughts or comments are welcome and appreciated.
The following problem has come up several times:
The DPOS displays a "1" adjacent to the file name on the LS's DPOS page, a current status of "wait" with a message that the system is determining "base file presence". When I see this it typically indicates there was a problem downloading the base file data to the rover.
My typical process is to connect the LS and T2 and download the base file. Generally this solves the problem. Today it didn't.
I deleted the file from the DPOS page on the LS, connected the LS and T2, downloaded the base file, went back to the DPOS page on the LS and the file is not in the list.
I have 2 questions:
1. Any thoughts on recovering this file? I downloaded the unprocessed point file to my PC before deleting above.
2. Since I am not seeing other complaints about this, there must be a problem with my process. I survey and download the point file (T2 to LS), disconnect and powerdown the LS, T2 and radio. Should I add to or modify this procedure to avoid this problem.
This comes up about every 5th project. Any thoughts or comments are welcome and appreciated.