To post-process in netview with receivers powered up, connected on physical USB to the computer but using SER, click connect and I get the message above. I have done this probably 100 times. I believe I'm following the same process. I don't recall have ever received this message. I have restarted netview, the computer, off/on the receiver, switch cables, switch usb port on computer and the problem follows one of the two receivers.
I think this is the first time I have post processed since I was learning and did RTK with the Victor-LS. Could a parameter within the TR2 have been changed?
Any ideas what's wrong?
I think this is the first time I have post processed since I was learning and did RTK with the Victor-LS. Could a parameter within the TR2 have been changed?
Any ideas what's wrong?