support

[Jim Campi]

I just sent a file to you with file name vezer williams. This is a small topo (less than 100 points) that was shot with the LS and T2. Max base line was 500 ft. I ran dpos on the file with no issues. When I try to transfer I get an error that there are 0 points in the file. It's obvious from selecting points from the home screen that there are 5 pages of points.

I really need this data. Any thoughts on how to recover?

 

[pappassurveyor]

I just sent a file to you with file name vezer williams. This is a small topo (less than 100 points) that was shot with the LS and T2. Max base line was 500 ft. I ran dpos on the file with no issues. When I try to transfer I get an error that there are 0 points in the file. It's obvious from selecting points from the home screen that there are 5 pages of points.

I really need this data. Any thoughts on how to recover?

You may have a filter turned on, hiding your points on for export. when you go to the export page makes sure you export all project points and make sure you uncheck "todays data only" Hope this helps.

 

[Nate The Surveyor]

Papa above is probably right.
Some filter is on, or you have the export format set to something other than csv. That's comma separated values
N

 

[Jim Campi]

Thank you gentlemen. I will check on this first thing in the am.

 

[Jim Campi]

Thank you gents. I believe you saved my project!!!

The problem was as pappa indicated "today's data only" had been checked. I have no clue how that occurred.

Thanks again!