T1M Upgrade
- Thread starter Ryan
- Start date
Phillip Lancaster
Active Member
go into netview and check the box by the constellations and remember to hit apply.
Parameters, Positioning, Main then check what you got.
Parameters, Positioning, Main then check what you got.
It's been a long while since I've used Netview. I downloaded the X64 manual update version 2.2.3.7, plug in the usb cable to reciever first, then
PC, open Netview and power on reciever. Connection mode is set to: Receiver. I clicked the connect button next to COM1 and COM2 and I get "reciever not found" message.
What am I doing wrong?
PC, open Netview and power on reciever. Connection mode is set to: Receiver. I clicked the connect button next to COM1 and COM2 and I get "reciever not found" message.
What am I doing wrong?
John Thompson
Well-Known Member
I don't know if the T1M is the same as the T2 in this regard, but I had a similar situation with the T2. If the constellations are enabled with Netview, try a long press on Reset Engines. https://support.javad.com/index.php?threads/good-news.4294/post-41604
Like your photo, my Base GNSS Status still shows only GPS and GLN even though it is using 4 constellations for RTK.
Like your photo, my Base GNSS Status still shows only GPS and GLN even though it is using 4 constellations for RTK.
You don't need Netview and modem for anything.
See this thread:
support.javad.com
See this thread:
Multi-Constellation with Standard LS - Tips for getting started
I've sent this (or versions of it) to a few customers now. I'm bringing it here for your reference. On the Triumph-LS: Make sure that you have the latest versions of software installed. Make sure that GPS, Glonass, Galileo and Beidou are turned on. Go to Setup and Edit the General Group...
You don't need Netview and modem for anything.
See this thread:
Multi-Constellation with Standard LS - Tips for getting started
I've sent this (or versions of it) to a few customers now. I'm bringing it here for your reference. On the Triumph-LS: Make sure that you have the latest versions of software installed. Make sure that GPS, Glonass, Galileo and Beidou are turned on. Go to Setup and Edit the General Group...
I have seen it and followed the instructions. I just thought I would see the base tracking more than 2 constellations under "Base GNSS Status".
Thanks
I think the base GNSS status is wrong
Yes, you are right, Shawn.
Only TRIUMPH-3 base GNSS status is supported correctly in the current J-Field version. Just ignore and move click by Start Base