Translate and rotate

Sorry I’m kind of a novice we had a PLS who was using the triumph ls quit, and basically the unit was dumped in my lap to figure out and I’m struggling in some spots with the manual. When I import calc points how do I translate and rotate them to my surveyed points?
 

Matt Johnson

Well-Known Member
5PLS
Shift and Rotate are covered in the Quick Start Guide:

9162


9163



You could also use a localization which is covered in the User's Guide.
 
Yea so back to my original question where I mentioned I was having trouble with the manual, the same one you sent pics of. I just want to translate a design point to equal a survey point then bring in the range of points to shift with it. Then rotate the bearings to another point but the manual is vague to say the least and uses different verbiage than what I’m used to. Trying to use those instructions above I’m basically just guessing past selecting the points to move.
 

Matt Johnson

Well-Known Member
5PLS
I’m basically just guessing past selecting the points to move.

So the 2nd step is to use the Delta button to calculate the translation values.

9164


Then you just press the Move button to translate the points.

Then you must rotate that same group of points around the design point (PB) that you must moved to the survey point.
 

Rpetre

New Member
I used your same scenario to move and rotate a simple box around some field points as a test. When I move the alignment/polyline it looks good on the preview, when I hit move it flashes, shows the moving points screen at 0.00% with the wheel frozen and the smile face button cycles red, yellow, green. I have to hold down the power button to get it to reset. When it reboots the move was completed and looks right but not sure why it froze? Then I tried the same operation with the rotate. First time it worked but the second time it froze the same as when doing the move?
 

Adam

Well-Known Member
5PLS
I used your same scenario to move and rotate a simple box around some field points as a test. When I move the alignment/polyline it looks good on the preview, when I hit move it flashes, shows the moving points screen at 0.00% with the wheel frozen and the smile face button cycles red, yellow, green. I have to hold down the power button to get it to reset. When it reboots the move was completed and looks right but not sure why it froze? Then I tried the same operation with the rotate. First time it worked but the second time it froze the same as when doing the move?
Sounds like a bug. Are you up to date?
 

Michael Stazhkov

Developer
JAVAD GNSS
Please send the project to support (Projects screen -> "Send The Project To Support" button) and tell the device serial number or the project name.
 
Top