Bruce Dawson
Active Member
Okay, so I had a situation today where I was trying to tie a monument that was on the edge of my radio range. I would get green signal, then it would drop out for a bit, then come back. After a while I switched to a Standalone profile thinking it would be more efficient to just gather post process data for 10 minutes or so. Unfortunately the radio would come in just long enough to reset my time-on-point display and things would start over again. Is there a way to temporarily turn off the UHF radio receiving process on a point? Am I not losing data when it resets the timer? Perhaps there is a setting in that Standalone profile that ignores UHF?
Thanks for any input!
Thanks for any input!