Jim Frame
Well-Known Member
This morning when I set up my base using the T-LS, I was unable to get corrections. The T-LS was talking to the base, and the T-2 appeared to be talking to the radio, but when I looked at the UHF parameters, it showed the base radio as a T-1 Internal. All the other radio choices were grayed out. After mucking around through different screens I was able to change the radio designation to the HPT401BT, though I'm not certain it didn't stay gray even with the button checked. In any case, still no corrections.
I rebooted everything, and the radio was correctly identified, after which everything worked fine.
Is there a particular order of starting and connecting the various bits that I should follow to avoid a repeat of this?
I rebooted everything, and the radio was correctly identified, after which everything worked fine.
Is there a particular order of starting and connecting the various bits that I should follow to avoid a repeat of this?