Changing rod height?

avoidthelloyd

Active Member
Well… I didn’t it again… took 10 shots and forgot to change the rod height on my LS. I went to Points and edited the subject shots and typed in the correct rod height and it prompted me asking if I really wanted to. I said OK. It showed the change, but when I went back to one of the points to look at something else, the wrong original rod height was there. I tested it again and it will not save the change? I ended up changing the description and typing in the numbers needing raised as my work around. How do I change the rod height/raw data?
 

Shawn Billings

Shawn Billings
5PLS
Nate is correct. If you're using arrows at the bottom of the screen to go to the next point, edit it and arrow to the next point then the changes won't take. You must ok the edit and return to the point list.
 

Andrey Zhiganov

Active Member
5PLS
You can use the setting to apply the changes using the navigation arrows in Edit Point.

Screenshot from 2021-07-18 12-30-28.png
Screenshot from 2021-07-18 12-30-51.png


You can also use "Batch Edit" to change the rod height of the points in the list.

Screenshot from 2021-07-18 12-36-52.png
Screenshot from 2021-07-18 12-37-02.png
 

John Thompson

Active Member
I would like to have a button on the antenna height screen that would recall the last antenna height with one touch. It would be useful for times when I change the height for one or a few shots and then I want to change it back to what it was before. I often switch between two antenna heights (on the pole and off), and I could toggle between them with one click. (Well, two. Antenna height, and recall last.)
20210718-20.07.21_00319_Measured_Height.png
 

avoidthelloyd

Active Member
I’ll give it try. Thank you all. I didn’t use the next arrows at all. After I noticed it, I only used a single point to test it over and over by clicking okay. Batch edit is what I needed. Thanks.
I would like to have a button on the antenna height screen that would recall the last antenna height with one touch. It would be useful for times when I change the height for one or a few shots and then I want to change it back to what it was before. I often switch between two antenna heights (on the pole and off), and I could toggle between them with one click. (Well, two. Antenna height, and recall last.)
View attachment 11597
that’s would be handy. It works when you click OK three times. Once in the screen where you type it in, again on the pop up and the last time at the bottom right of the edit screen. I was only getting the first two.
 

Matt Johnson

Well-Known Member
5PLS
I would like to have a button on the antenna height screen that would recall the last antenna height with one touch. It would be useful for times when I change the height for one or a few shots and then I want to change it back to what it was before. I often switch between two antenna heights (on the pole and off), and I could toggle between them with one click. (Well, two. Antenna height, and recall last.)
View attachment 11597
There are already two options to recall saved values. You can use Profiles to save and recall antenna heights or the MS or MR buttons.
 
Top