David M. Simolo
Well-Known Member
Yesterday I used my T-LS & T-2 combo as usual, all seemed to go as normal.
Back in the office I went to DPOS my results and noticed the DPOS screen characteristics looked odd but wasn't really paying attention--in hindsight it was because it only showed 2 points in the point file. I continued with the DPOS process which resulted in the attached screen image.
I suspect my base download session got corrupted somehow as it only showed 2 points on the point list--the base point and one other. There were 61 points collected on the job and I would say "collect GNSS data" was selected on almost all of them if not all of them.
I deleted the file from the SD card and redownloaded it from the base but it was still the same point list with only 2 points. So I rebooted both units and went to download them again. I deleted the file from the SD card again. Then I got the bright idea of deleting the session from the list of files that could be DPOS'd--that may not have been too smart as I am now stumped on how to proceed.
I'd rather not lose all the data due to my lack of knowledge on how to navigate through this problem.
Also, I used the units today and went through all the above normal procedures without a hitch so this problem would appear to be only specific to yesterday's work.
Any advice out there?
Thanks in advance.
Dave.
Back in the office I went to DPOS my results and noticed the DPOS screen characteristics looked odd but wasn't really paying attention--in hindsight it was because it only showed 2 points in the point file. I continued with the DPOS process which resulted in the attached screen image.
I suspect my base download session got corrupted somehow as it only showed 2 points on the point list--the base point and one other. There were 61 points collected on the job and I would say "collect GNSS data" was selected on almost all of them if not all of them.
I deleted the file from the SD card and redownloaded it from the base but it was still the same point list with only 2 points. So I rebooted both units and went to download them again. I deleted the file from the SD card again. Then I got the bright idea of deleting the session from the list of files that could be DPOS'd--that may not have been too smart as I am now stumped on how to proceed.
I'd rather not lose all the data due to my lack of knowledge on how to navigate through this problem.
Also, I used the units today and went through all the above normal procedures without a hitch so this problem would appear to be only specific to yesterday's work.
Any advice out there?
Thanks in advance.
Dave.