Robert P Stenerson
Active Member
Yesterday I was staking some points for a boundary survey, and this was my second occupation on my base point, so I was using my first adjusted Base point for yesterday's work. Before I take down my base I always bring my LS out near the T2 and use the Base/Rover Setup to reconnect via Bluetooth, Stop and Download the Base point for that session, and wait for the little green download circle to complete, after which I press Done, and then I start the tear down of the equipment.
Today I tried to go into the COGO, DPOS, and selected the Base point for yesterday, and it says that I'm still downloading it???
Okay, I think maybe it didn't complete, so I go and reconnect to the T2 via blue tooth
then I click on Done to get back to the COGO DPOS screen and I click on the Download button, and I get this:
This is no big deal since I was just staking yesterday, but it would not be okay if this was my initial session. Does anyone have a work around when the Base to LS download doesn't complete?
Thanks,
Rory
Today I tried to go into the COGO, DPOS, and selected the Base point for yesterday, and it says that I'm still downloading it???
Okay, I think maybe it didn't complete, so I go and reconnect to the T2 via blue tooth
then I click on Done to get back to the COGO DPOS screen and I click on the Download button, and I get this:
This is no big deal since I was just staking yesterday, but it would not be okay if this was my initial session. Does anyone have a work around when the Base to LS download doesn't complete?
Thanks,
Rory