Incorrect vertical when point staking known points.

[Michael Stazhkov]

Hello. I have a Triumph LS/Triumph 2/HPT401BT. Prior to this last update, I've never encountered these issues checking into known points.. The horizontal is good, but the vertical is incorrect by a constant elevation. When I set up the RTK base unit, I always point stake to occupied base point, and the vertical and horizontal are good. But then, in the same session, I check into every known point (with a good fix and radio) on our baseline and we are always 5' high. I've double checked to ensure the points have been accurately edited to reflect differential leveling. I've also double checked to ensure the monopod rod height and units are correct. Any ideas?

The issue with incorrect vertical should be fixed in 2.0.0.219.

 

[Jim Frame]

Can you clarify the circumstances under which this bug occurs? If it's universal, it would seem that a high priority update to the release version would be in order.

 

[Mike C.]

So I updated this morning and am in the field and everything is working smoothly. Thanks!

 

[Joe Paulin]

Hi Jim, it's my understanding that the .219 update was the high priority fix.

 

[Matt Johnson]

The last rover antenna height is stored in every project. This antenna height was not being applied when a project was opened so if the antenna height from the previously opened project was different than was stored antenna height in the project that was just opened, this bug occurred. However, as soon as the rover antenna height was edited, the change would have been applied.

I don't believe this bug would have been seen very often and I don't think it was what Mike may have seen.

 

[Mike C.]

You're probably right Matt. Thanks again.