John Thompson
Well-Known Member
I just noticed that I can click on the little diagram on the inverse screen and it shows a map with P1 and P2 and a line joining them. Nice.
That map screen has a lot of blank space. Looks like it would be really handy to be able to inverse from point to point to point... by selecting them on that map. It would be great to be able to snap to linework on the map too.
I recently needed to inverse between several points by choosing them from the map. As currently configured, it takes a lot of clicks. I did find the 'Confirm selection' checkbox which saves a few clicks, but the map always reverts to 'zoom to extents' each time a point is selected.
That map screen has a lot of blank space. Looks like it would be really handy to be able to inverse from point to point to point... by selecting them on that map. It would be great to be able to snap to linework on the map too.
I recently needed to inverse between several points by choosing them from the map. As currently configured, it takes a lot of clicks. I did find the 'Confirm selection' checkbox which saves a few clicks, but the map always reverts to 'zoom to extents' each time a point is selected.