Jim Frame
Well-Known Member
Some months ago I did a localization that worked well as an aid to searching for monuments. I haven't tried the technique again until today, and this time I wasn't able to get it to work. I'm hoping someone smarter than me can tell me where I went wrong. Here's what I did:
1. I entered some approximate coordinates calculated from a record map and overlaid on a georeferenced image to produce rough SPC values (CA Zone 2).
2. I created a page named RECORD and imported the coordinates to it.
3. I created a page named CONTROL set up for SPC and located 4 of the monuments using my local RTN.
4. I created a localization by holding the 2 farthest monuments and using the 2 in between as checks:
4. I created a page named SEARCH set up to use the Local Yolo CS:
5. I tried staking out one of the monuments in the SEARCH page:
However, I missed it by the shift magnitude between coordinate systems.
Where'd I go wrong?
Thanks!
1. I entered some approximate coordinates calculated from a record map and overlaid on a georeferenced image to produce rough SPC values (CA Zone 2).
2. I created a page named RECORD and imported the coordinates to it.
3. I created a page named CONTROL set up for SPC and located 4 of the monuments using my local RTN.
4. I created a localization by holding the 2 farthest monuments and using the 2 in between as checks:
4. I created a page named SEARCH set up to use the Local Yolo CS:
5. I tried staking out one of the monuments in the SEARCH page:
However, I missed it by the shift magnitude between coordinate systems.
Where'd I go wrong?
Thanks!