avoidthelloyd
Active Member
I've noticed a real lag in my LS+ performance lately. I've been using the same settings for a while with the only difference is preprogramming each engine to use certain channels to help reach the variety setting. I use the precise topo setting most of the time.
How it behaves: When I walk into the woods and get ready to take a shot (just normal amount of canopy, not too thick) I stand the rod up and it's usually green and showing 2-3 satellites locked. As soon as I click Start, it immediately clicks once and then nothing most of the time. It had some locked until I clicked start. I usually can place my hand on the top for a second and it might collect another click or three after I move it off. It's frustrating.
What's weird to me is that I can leave it right where it is at and reboot it and when I click start it will complete the full shot in seconds? I might get another couple of shots before it slows back down again. If I ever get to taking to long to progress on a shot almost anywhere, I can reboot it and it will take the shot easily.
This LS+ was sent in for repair and I'm not positive of what all was replaced, but what would cause it to progress through the shot after a reboot when it struggles to complete one? This is regular behavior in multiple conditions... sometimes in mostly open areas. I'll try to video it if I remember.
What would you look at?
How it behaves: When I walk into the woods and get ready to take a shot (just normal amount of canopy, not too thick) I stand the rod up and it's usually green and showing 2-3 satellites locked. As soon as I click Start, it immediately clicks once and then nothing most of the time. It had some locked until I clicked start. I usually can place my hand on the top for a second and it might collect another click or three after I move it off. It's frustrating.
What's weird to me is that I can leave it right where it is at and reboot it and when I click start it will complete the full shot in seconds? I might get another couple of shots before it slows back down again. If I ever get to taking to long to progress on a shot almost anywhere, I can reboot it and it will take the shot easily.
This LS+ was sent in for repair and I'm not positive of what all was replaced, but what would cause it to progress through the shot after a reboot when it struggles to complete one? This is regular behavior in multiple conditions... sometimes in mostly open areas. I'll try to video it if I remember.
What would you look at?
