avoidthelloyd
Active Member
Friends, I can start my base on a known coordinate and then stake out to my base within a few tenths of it on fairly level ground and I'm getting ±0.35' bust.
Here's the situation and conditions and you tell me what you think is going on...
Here's the situation and conditions and you tell me what you think is going on...
- It's a new T3NR base and the only change in my setup and equipment. My T3 was in the shop.
- I've checked this way on the last three projects with the same result and one is an existing project I've been to 4 other times in the past year with no problems.
- The position I report is ±0.35' too low. It says Fill.
- I measure the base height and rod heights carefully.
- The Ant. Height on my LS+ is matching the physical rod height.
- The same error on all my other control points in the project (it's consistent).
- Confirmed no vertical offsets are applied to the base. It is 0'. I've never used this feature.
- Project settings are what I always use (NAVD88) and the geoid is the same as always.