Since 3.0.10.402:
- RTPK 3.0 (additional checks of a fixed solution validity, improved performance)
- RTPK 3.0 (additional checks of a fixed solution validity, improved performance)
Does this apply to T-2 LS folks too, or does it only apply to T-3 LS+ Folks?
The RTPK 3.0 engines does the following to validate the solution. The raw data is divided into 2 minute sections and processed in sections. The coordinates from each section are compared to check if they agree. If there are 2 sections that agree then the solutions are averaged and a result is returned, otherwise processing is marked as failed and a result is not provided. If there is less than 2 minutes of data then the data is divided in half.
Note that I have found a bug in this version: The issue is if initially a point is processed with a short duration of data and yields a fixed result but then it is reprocessed with more data and fails, the previous fixed result is not deleted.
Has .413 pre release update fixed this bug?The RTPK 3.0 engines does the following to validate the solution. The raw data is divided into 2 minute sections and processed in sections. The coordinates from each section are compared to check if they agree. If there are 2 sections that agree then the solutions are averaged and a result is returned, otherwise processing is marked as failed and a result is not provided. If there is less than 2 minutes of data then the data is divided in half.
Note that I have found a bug in this version: The issue is if initially a point is processed with a short duration of data and yields a fixed result but then it is reprocessed with more data and fails, the previous fixed result is not deleted.
Has .413 pre release update fixed this bug?
Could you send the project to support (Projects screen -> "Send Project to Support" button).running .413 and getting this message all day never seen before, , (no solution for this vector) RTPK results even in open area not good,
only seemed to have 5 engines in good conditions all day. anyone else have this issue?
That occurred to me too, I had done it the day before but after the update I should have done it again.I wonder if clearing NVRAM on the base would help. With only 5 engines fixed, it sounds like you might not have all of the signals in your corrections.
That occurred to me too, I had done it the day before but after the update I should have done it again.
[/QUOT
cleared the NVRAM resent profile to base, RTPK not working as well as before update to .413
never got 6 engines yesterday. Going back to Release to see if it improves.
How are 2D Delta and Delta H on your base setup?